Product Description:
To bend the pipe of O.D 11/4" to 11/2" inches that the rate of bending radius and outside diameter is below 2 times, mandrel is necessary which isn't the equipment of MJ-A.
Product Description:
This type has the function of multiple protection, so the body life is extended and the rate of breakdown is very low. According to purchaser's, portable mandrel can be worked for complex angles without wrinkles, disfigures... It's workable for any kind of materials, such as steel, stainless steel, aluminum, lead, copper.... No shape limit such as round, square, flat, L.T. and other shapes of pipes. It's unsuitable for the pipe with O.D. above 30mm, or rate of bending radius and O.D. below 2 times.
Product Description:
NC type can pre-set 21 angles continuously. NC type is equipped with numerical controller of single axis to adjust the tolerance easily. Therefore, NC type cuts down the loss of pipe material to the minimum, also increases the accuracy. Equipped with OMRON PLC, higher stability, easier maintenance. Easy to operate, special training is unnecessary for users.
Product Description:
NC type can pre-set 21 angles continuously. NC type is equipped with numerical controller of single axis to adjust the tolerance easily. Therefore, NC type cuts down the loss of pipe material to the minimum, also increases the accuracy. Equipped with OMRON PLC, higher stability, easier maintenance. Easy to operate, special training is unnecessary for users.
Product Description:
CNC fully automatic pipe bender is the top technology production in this field. All the pulling, rotating and bending pipe are controlled by computer and work fully automatically without extra stop equipment. This type is more suitable for complex pipe industry, such as exhaust pipe, air conditioner pipe, water heater.
Product Description:
Equipped with PLC system. Double bending on same time with maximum 120 degrees. It can be set two different angles and bending on same time. No mandrel using that fasten the bending speed. 5. Especially suitable for pipe bending of furniture and out-door series production.
Product Description:
Equipped with PLC system. Double bending on same time with maximum 120 degrees. It can be set two different angles and bending on same time. No mandrel using that fasten the bending speed. 5. Especially suitable for pipe bending of furniture and out-door series production.
